
PERSEPHONE AWAITS
Bold, bordered diamonds
Dynamic dimension with angles
1.
Gather and cut your fabric
Once you have your fabric cut, pair the diamonds with a surrounding fabric.

2.
Make your blocks
Sew a strip to the side of a diamond. Press and trim.


Sew the strip to the opposite side of the diamond. Be sure to offset the strip 1/4” to accommodate for the seam allowance. Press and trim.


Sew the strip to the third side of the diamond. It might be oriented in either of the following ways:


Press and trim then sew remaining piece to the last side of the diamond.
Trim any remaining pieces to create a perfect diamond.


3.
Arrange your blocks
Arrange your blocks on the wall.

4.
Sew diamond rows on point
Sew the rows together on point – on an angle. The diamonds will be offset 1/4” to accommodate for the seam allowance.



4.
Trim your top
I chose to trim the points of this quilt BEFORE quilting the top. I marked 1/2” from the top of the points of the quilt then based next to the mark prior to trimming this. I basted first so I could secure the bias edges of the triangles and prevent stretching the top while I was quilting it.

Here’s roughly how I trimmed the quilt. The lines in the photo aren’t perfect but should give you enough of an idea where I trimmed to create a rectangle or square quilt.


5.
Quilt, bind and enjoy
I quilted this using on my domestic machine using my walking foot.


I used scrap bias binding to bind the edges of the quilt.
