
LITTLE LONE STAR
A new twist on an old favorite
Unlock your scrappy genius
1.
Gather and cut your fabric
Pick a set of colors you like. I used a combination of brightly colored fabrics that work well together. Remember: the fabric doesn’t have to match perfectly. The pieces just need to get along.

2.
Sew 12 strip sets
Sew 12 strip sets of 4 fabrics. Press seams open.

3.
Cut your pieces
Cut your pieces on a 45 degree angle.

4.
Lay out the quilt
Lay out your Lone Star points before you begin sewing them together. This ensures you have pieces where you want them before sewing them together.

5.
Create the Lone Star points
Sew 8 Lone Star points. Each Lone Star point is made up of 4 strips cut in step 3. Here you see two Lone Star points.

6.
Sew Lone Star Points
Sew two Lone Star points together. Stop 1/4” from the outside edge so you can create a Y-seam. Backstitch. Press.


7.
Create one half of the Lone Star
Repeat the step above then sew 4 Lone Star points together to create one half of the Lone Star center. Press all your seams in the same direction so can furl the center once the two halves are sewn together.
The detail photo on the right shows how the Lone Star points are sewn together and pressed in the same direction.


8.
Detail of front
In an ideal world, you’ll have perfect points.
Also: galloping horses.

9.
Sew two halves together
In an ideal world I would have a photo to show with all 8 points sewn together and no background fabric. I do not but this shows how the two sections are sewn together without the background.

10.
What is a Y-Seam?
Y-Seams are created when three pieces of fabric are sewn together at an angle, creating a Y.
On the Little Lone Star there are Y-Seams at each corner and along the top and side edges.


11.
How to make a Y-Seam
I begin by placing the fabric right side up so I can see how the quilt will finish.

Then I flip the piece I’m inserting into the Y-Seam so right sides are together.

Next, I mark 1/4” from the corner and stick a pin in it.

Insert the straight pin into the intersection of the Lone Star. The pin will go into the intersection of the two Lone Star points, exactly 1/4” away from the edges.

Pin the seam.

Put your sewing machine needle directly through the intersection. Sew the pieces together, making sure you backstitch while being careful not to catch the fabric from the Lone Star points under your needle. Sew the seam.

Repeat this for the remaining side to complete your Y-Seam. When it’s finished, the back (intersection? corner?) should look like this.

Press the seams in the same direction to furl the intersection.

Repeat for the side setting triangles.
The side setting triangles are larger than necessary to allow you to trim them when you square up your quilt top.






12.
Quilt, bind and enjoy!
The dreaded last words but once the top is finished it is time to quilt, bind and enjoy it.
I’ve made several Little Lone Stars and I really like to quilt using circles. I quilted all of these on my machine.
This quilt has concentric circles. I began in the middle and quilted out. The circles are evenly spaced.

This quilt also has concentric circles at varying distances apart. This was done so I could add big stitch quilting between the circles.


